Can only the category 7 network cable be connected with the connector of the category 7 network cable? How to pick it up?

ategory 7 network cables can only be connected with Category 7 crystal plugs. You can't plug it in even if you use other ones, so several types of network cables use several types of crystal heads.
Category 7 wire is an 8-core shielded wire, each pair has a shielding layer (usually a metal foil shielded Foil Shield), and then there is a shielding layer outside the 8 cores (usually a metal braided wire mesh shielded Braided Shield), The interface is the same as the current RJ-45. Total shielding (usually metal braided screen shielding) + wire-pair shielding (usually metal foil shielding) Category 7 line S/FTP Cat.7 (HSYVP-7) The highest transmission frequency is 600MHz, and the transmission frequency of Super Category 7 line is 1000MHz .

First of all, we prepare the tools: seven types of crystal heads, small cards of the crystal head, wire strippers, diagonal pliers, seven types of Network Cable pliers, and line testers.

Step 1: First use a wire stripper to strip about three centimeters in length, and then you will see a shielding layer. After cutting off the outer skin and easy wire, twist the braid and ground wire into one strand. Then cut off the aluminum foil wrapping the wire pairs.
Step 2: Then we arrange them according to the T568B line sequence, orange-white, orange, green-white, blue, blue-white, green, brown-white, and brown. After arrangement, straighten the line and cut the line with diagonal pliers. Because our thread is relatively thick, it won’t fit in if you do it in the usual way, so we have to cut it diagonally, and insert the small card after it’s cut.
Step 3: Let's measure the crystal head. When cutting the cable, reserve about half a centimeter. After cutting, push the network cable into the crystal head and push the core wire to the forefront. You can check from the front end of the crystal head to see if the wire core is fully pushed to the forefront.
Why should it be reserved for so long? Because one of the convenient threads is shrunk, then press it with a network cable pliers, and then trim off the excessively long braid and ground wire. Our seven types of crystal heads are half done.
The last step: pull the tail wing of the dovetail clip of the crystal head slightly inward to make it fully contact with the braid and the ground wire. Then press it with the network cable pliers, and our crystal head will be very firmly combined with the wire.
After it’s done, let’s test it with a cable tester. If the test lights flash from 1-G one by one in sequence, the network cable is connected. Have you learned?
If you find it troublesome, you can directly contact Shenzhen Kaiweier Electronics Co., Ltd., a professional network jumper manufacturer, to directly provide you with finished network cables, plug and play, convenient and fast, and quality assurance.